Smeg B70CMSX5 Manuel d'installation Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
Instructions for the Installer
86
The appliance has a terminal board on its rear. Make the
electrical connection in accordance with the wiring diagram
shown below.
To access the terminal board, remove the guard on the rear.
Operation at 380-415V 3N~: use a H05RR-F / H05RN-F /
H05V2V2-F five-wire cable (cable of 5 x 2.5 mm
2
on 90 cm model or
5 x 1.5 on 60 cm model).
Operation at 380-415V 2N~: use a H05RR-F / H05RN-F /
H05V2V2-F four-wire cable (cable of 4 x 4 mm
2
on 90 cm model or 4
x 2.5 on 60 cm model).
Operation at 220-240 V~: use a H05RR-F / H05RN-F / H05V2V2-F
three-wire cable (cable of 3 x 6 mm
2
on 90 cm model or 3 x 6 on 60
cm model).
The earth wire (yellow-green) must be at least 20 mm longer than
the other wires at the end for connection to the appliance.
The power supply cable must be fitted with a suitable five-pin plug (see technical data plate) or, for
appliances operating on 220-240 V, a three-pin plug. The power supply plug and wall socket must be of
the same type and compliant with the relevant regulations. Check that the appliance is earthed
appropriately. Before putting the appliance into operation, check that the power supply line is properly
earthed. The use of adapters or junctions is not recommended.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR INJURY OR DAMAGE CAUSED BY
FAILURE TO COMPLY WITH THE ABOVE REGULATIONS
13.2 Fitting the rear splash-back
Unscrew the nuts B.
Place the splash-back on the hob, aligning the rods
C with the holes D.
Fix the splash-back to the hob by tightening the
screws A.
13.3 Positioning and levelling the appliance (depending on model)
After making the electrical and gas connections, level the the appliance on the ground by means of its
four adjustable feet. For good cooking results, the appliance must be properly levelled. Depending on the
model you have purchased, the foot height adjustment range may vary from 70 to 95 mm and from 110
to 160 mm. These heights refer to the distance between the highest point of the foot (fixed part) and the
lowest point (movable part which rests on the floor).
914772936/ A
Vue de la page 15
1 2 ... 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire