Smeg A42-6 Manuel d'utilisateur

Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 34 2. INSTALLATION OF THE APPLIANCE ______________________________ 36 3. A

Instructions for the user 42 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel.

Instructions for the user Intermittent going on and off of the light means that oven temperature is being constantly maintained at the programmed

Instructions for the user 44 5.2 Electronic Analogue Clock LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC SWITCH-OFF TIMING BUTTON TIM

Instructions for the user 5.2.2 Minute-minder This function does not stop cooking but just triggers the beeps. - When the key is pressed the d

Instructions for the user 46 5.2.3 Programming Cooking duration time: the 2nd button can be used to set the cooking time. Before setting it, tu

Instructions for the user Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours

Instructions for the user 48 6. USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the

Instructions for the user 6.2 Practical advice for using the cooking hob burners For better use of the burners and lower gas consumption, use cove

Instructions for the user 50 7. USE OF THE OVENS 7.1 Warnings and general advice Before using the oven for the first time, pre-heat it to maximu

Instructions for the user 8. AVAILABLE ACCESSORIES The main oven has 4 support for positioning plates and racks at various heights and has uppe

Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY A

Instructions for the user 52 9. COOKING HINTS During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pa

Instructions for the user 9.2 Hot-air grilling FUNCTION SWITCH Ensures uniform heat distribution with greater heat penetration into th

Instructions for the user 54 9.4 Defrosting THERMOSTAT IN POSITION The flow of air produced by the fan ensures quicker defro

Instructions for the user 9.6 Delicate cooking THERMOSTAT SWITCH IN POSITION Ideal for pastries and cakes with wet covering and little

Instructions for the user 56 9.8 Spit cooking FUNCTION SWITCH This type of cooking is only for the main oven. Use it for small size

Instructions for the user 10. CLEANING AND MAINTENANCE Before performing any operations requiring access to powered parts, switch off the powe

Instructions for the user 58 10.2.2 Burner caps and flame cap crowns The caps and flame-spreader crowns are extractable to facilitate cleaning. Wa

Instructions for the user 10.3.3 Looking after the self-cleaning liners The liners should not be cleaned with abrasive creams or ordinarydetergen

Instructions for the user 60 11. EXTRAORDINARY MAINTENANCE Ovens periodically require small maintenance interventions or replacement of parts sub

Instructions for the user 11.2 Removing the door Open the door completely and fit the pins (supplied) into the holes from the inside. Close the

Introduction THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS VISIBLY POSITIONED ON THE REAR PROTECTIVE COVER OF THE APPLIA

Instructions for the installer 36 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Cor

Instructions for the installer 37 Twin oven model The appliance comes with a terminal board on the back for electrical hook-up (see following diag

Instructions for the installer 38 2.2 Ventilation requirements The room containing the appliance should have an air supply in accordance with B.S.

Instructions for the installer 39 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the applia

Instructions for the installer 40 3.2 Burner and nozzle characteristics table Rated Burner heating capacity (kW) LPG – G30/G31 28/37 mbar

Instructions for the installer 41 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the