Smeg DRY50V Manuel d'installation télécharger pdf (Page 4)

Instructions for the installer

2. INSTALLATION OF THE STERILIZER

The sterilizer must be set up on a perfectly flat surface and left standing

free. Make sure to allow enough room at the back for easy access to the

terminal strip for connection of the power cable to mains.

Installation must be carried out by a qualified technician in compliance

with applicable regulations in force.

2.1 Electrical connection

Make sure that the power line voltage matches the specifications

indicated on the rating plate located to the rear of the sterilizer. This

rating plate must never be removed.

The sterilizer is supplied complete with a H07RN-F three-core supply

cable for operation from a 230V∼ power supply.

The standard cable is of the three-core

3 x 1.5 mm

H07RN-F type.

If necessary the electrical supply cable

should be replaced with an oil-resistant

type (min. H05RN-F 3 x 1.5 mm

The (yellow/green) earth cable on the

end of the cable to be connected to the

sterilizer should be at least 20 mm

longer.

Make sure that plug and wall socket are of the same type and are in

conformity with regulations in force. Also check that the power supply

line is provided with adequate earthing. Avoid using adapters or

shunters.

In case of permanent connection, ensure that power cable is equipped

with an easily accessible omnipolar switch fitted in proximity to the

apparatus and with a gap between contacts equal to or greater than

3 mm.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Smeg DRY50V Manuel d'installation Page 4