Smeg A4BL-8 Manuel de service télécharger pdf (Page 45)

Instructions for the installer

11.3.2 Connection with a flexible steel hose

WARNING: The following instructions are valid for all types of installation,

see fig. A, B, C in chapter “11.1 Installing in kitchen units”.

Only use standards-compliant continuous wall steel hoses no longer than 2

metres.

This type of installation can be used for both built-in and free-

standing appliances.

Make the connection to the gas mains using a continuous wall

flexible steel pipe whose specifications comply with the

applicable standard.

Carefully screw the connector 3 to the appliance’s gas connector

1 (1/2” thread ISO 228-1), placing the seal 2 between them.

11.3.3 Connection with a flexible steel hose with conical fitting (where

present)

WARNING: The following instructions are valid for all types of installation,

see fig. A, B, C in chapter “11.1 Installing in kitchen units”.

Only use standards-compliant continuous wall steel hoses no longer than 2

metres.

This type of installation can be used for both built-in and free-

standing appliances.

Make the connection to the gas mains using a continuous wall

flexible steel pipe whose specifications comply with the

applicable standard.

Carefully screw the connector 3 to the appliance’s gas

connector 1 (½” thread ISO 228-1), placing the seal 2 between

them. Apply insulating material to the thread of the connector 3,

and then tighten the flexible steel pipe 4 to the connector 3.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Smeg A4BL-8 Manuel de service Page 45