Smeg TR4110IBL Manuel d'utilisateur télécharger pdf (Page 17)

Use

57

EN

Deactivating the hob power limit

1. Disconnect the cooker's power supply,

then wait 10 seconds before restoring

the power. At this point you have 2

minutes to change the power setting.

2. Turn both the front left and front right

cooking zone knobs to the left at the

same time, and keep them in this position

for 3 seconds. The rear left and rear right

cooking zone displays will show 3 and

0.

3. Release both knobs, then turn only the

knob for the front right cooking zone to

the left and hold it in position. The rear

left and rear right cooking zone displays

will show the new power value of 7 and

4.

4. Release the knob and wait a few

seconds until the display turns off. At this

point it will now be possible to use the

product at full power.

5. To return the product to its original setting

(power draw limited to 3 kW), repeat

the configuration procedure.

Error codes

If the display shows one of the following

error codes , , contact Technical

Assistance.

3.5 Using the storage compartment

The storage compartment is at the bottom

right of the cooker. It can be used to store

cookware or metallic objects necessary

when using the appliance.

After a prolonged period of

interruption to the power supply,

the control lock will be

deactivated. If this is the case, turn

it back on as described above.

The induction hob is configured to

draw a maximum of 3 kW for use

with limited power supply circuits,

but it is possible to remove this

limitation and allow it to run at full

power (7.4 kW).

The last power setting activated

will remain in memory even in the

event of the electricity supply being

cut.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Commentaires sur ces manuels

Pas de commentaire