Smeg DWI409C Manuel d'utilisateur télécharger pdf (Page 5)

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or

sides of the dishwasher may be placed up against walls or other

furniture units. If the dishwasher is installed near a heat source, fit the

special insulating panel to prevent overheating and malfunction of the

appliance. To ensure stability, install integrated or built-under

dishwashers only under continuous worktops, and screw them to the

adjacent units. To facilitate the installation procedure, the intake and

drain hoses can be positioned in any direction; make sure that the hoses

are not kinked, crushed or pulled too tightly.

Level the appliance on the floor using its adjustable feet. This operation

is essential for ensuring correct operation of the dishwasher.

Some models are equipped with only one adjustable foot at the rear,

which can be adjusted by turning the screw on the lower front part of the

appliance.

2.1 Water supply connection

Preventing the risk of clogging or damage: if the water pipe is new or

has not been used for a long time, before connecting to the water supply

check that the water is clear and free of impurities, to prevent damage to

the appliance.

The dishwasher must always be connected to the water system

with new hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY

Connect the intake hose to a cold water supply

with ¾” gas thread, inserting the filter

supplied

with the dishwasher.

Take care to screw the hose firmly into place

with your hands and then complete by

tightening about ¼ of a turn with pliers.

In dishwashers equipped with the

ACQUASTOP device, the filters is already

fitted inside the threaded ring.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Pas de commentaire

Smeg DWI409C Manuel d'utilisateur Page 5