Smeg ST1146SE Manuel d'instructions télécharger pdf (Page 16)

User instructions

FAULT - DESCRIPTION

Flow meter k.o. (for the relevant models only)

The appliance is not able to "measure" the amount of water loaded accurately. The alarm

is displayed at the end of the cycle, which however is completed since the problem

does not interfere with operation of the dishwasher. If the problem persists, contact

the after-sales service.

Zone washing k.o. (for the relevant models only)

Interrupt the program and switch off the dishwasher. Switch the dishwasher back on,

program it again and start the washing cycle. If the problem persists, contact the after-

sales service.

Press. switch k.o.

Contact the after-sales service.

x "Fault waterblock", "Safety level on", "Heating k.o.", "Temper.

feeler k.o.", "Zone washing k.o." and "Press. switch k.o." trigger

an immediate termination of the program in progress.

x "Watertap closed" and "Drain obstructed" interrupt the program in

progress and then continue it as soon as the cause of the problem

has been dealt with.

To “reset” an alarm is necessary:

x Open and close the door, or turn off and on the machine. At this

point is possible to program the dishwasher again.

If the fault persists, call the authorised Technical Service Centre.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Pas de commentaire

Smeg ST1146SE Manuel d'instructions Page 16