• If the appliance is not in a niche and can therefore be accessed on one
side, cover the door hinge area for safety reasons (cutting hazard). Covers
are available as accessories from specialized retailers or from the Technical
Service Centre.
•To build in the dishwasher, purchase the relative kit from specialized retail-
ers or from the Technical Service Centre.
5.1 Leveling
5.1.2 Levelling the appliance
Level the appliance using the relative adjustable feet (e.g.: ref. A fi g. 5-01); use
an open-ended wrench to rotate the feet until the dishwasher is perfectly level.
Some models are fi tted with just one rear foot which can be adjusted with a
screw located at the bottom front of the appliance (ref. A fi g. 5-02); use a suit-
able Phillips screwdriver or 8 mm hex head bushing to turn the screw until the
dishwasher is perfectly level.
Use a spirit level to check the appliance is perfectly level (ref. B fi g. 5-01).
Leveling is vital for assuring correct dishwasher operation.
Make sure to leave a gap of at least 3 mm (7/64”) between the top of the dish-
washer and the worktop (ref. C fi g. 5-01).
Fig. 5-01
• If the appliance is not in a niche and can therefore be accessed on one
side, cover the door hinge area for safety reasons (cutting hazard). Covers
are available as accessories from specialized retailers or from the Technical
Service Centre.
• To build in the dishwasher, purchase the relative kit from specialized retail-
ers or from the Technical Service Centre.
5.1 Leveling
5.1.2 Levelling the appliance
Level the appliance using the relative adjustable feet (e.g.: ref. A fig. 5-01); use
an open-ended wrench to rotate the feet until the dishwasher is perfectly level.
Some models are fitted with just one rear foot which can be adjusted with a
screw located at the bottom front of the appliance (ref. A fig. 5-02); use a suit-
able Phillips screwdriver or 8 mm hex head bushing to turn the screw until the
dishwasher is perfectly level.
Use a spirit level to check the appliance is perfectly level (ref. B fig. 5-01).
Leveling is vital for assuring correct dishwasher operation.
Make sure to leave a gap of at least 3 mm (7/64”) between the top of the dish-
washer and the worktop (ref. C fig. 5-01).
Fig. 5-01
Fig. 5-02
5.2 Connections
- yh dna l ac i r t ce l e eh t o t ssecca f o esae wo l l a o t sa os r ehsawhs i d eh t l l a t sn I
draulic connections through the adjacent unit. These connections must never
be behind the dishwasher.
The inlet and drain hoses can be pointed in all directions. make sure that they
are not bent, crushed or too tight. Tighten the ring nut after pointing the hoses
in the required direction.
Figure 5-03 indicates the distances to maintain between the dishwasher and
the various connections.
! DRAZAH ER I F
DO NOT COVER OR CRUSH THE CORD PLUG.
A = 1200 mm / 47”
B = 1500 mm / 59”
C = 1600 mm / 63”
A
B
D
C
Fig. 5-03
EN
13
INSTALLATION INSTRUCTION
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels