Smeg STU8642 Manuel d'instructions télécharger pdf (Page 22)

Connecting to the air gap (no waste disposal unit)



MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE

DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR

ON WHICH THE DISHWASHER WILL BE INSTALLED.

Connect the dishwasher drain hose (ref. A ﬁ g. 5-12) to the air gap (ref. B ﬁ g.

5-12) using the wide spring clamp (ref. C ﬁ g. 5-12); if necessary, cut the end

of the dishwasher drain hose (ref. D ﬁ g. 5-12) (do not cut the corrugated

section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”)

screw clamp*.

To connect the air gap (ref. B ﬁ g. 5-12) to the “T” union (ref. E ﬁ g. 5-12) of the

drain line, use a rubber union* (ref. F ﬁ g. 5-12) with spring or screw clamps*

(ref. G ﬁ g. 5-12).

* Available from any plumbing stockist

Fig. 5-12

INSTALLATION INSTRUCTION

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Pas de commentaire

Smeg STU8642 Manuel d'instructions Page 22