Smeg SD7220FND2P1 Manuel d'utilisateur télécharger pdf (Page 20)

Switching on

1. Connect the mains plug to the power

socket.

2. Press the appliance ON/OFF if the

display is off. The temperature

indicators show the set default

temperature.

The alarm buzzer could

operate after few seconds.

To reset the alarm refer to

"High temperature alarm".

To select a different set temperature refer

to "Temperature regulation".

If "dEMo" appears on the display, refer to

"Troubleshooting" .

Switching off

1. Press the appliance ON/OFF for 5

seconds.

The display switches off.

2. Disconnect the mains plug from the

power socket.

Temperature regulation

Set the temperature of the appliance by

pressing the temperature regulators.

Default set temperature:

• -18°C for the freezer

The temperature indicators show the set

temperature.

The set temperature will be

reached within 24 hours.

After a power failure the set

temperature remains stored.

High temperature alarm

An increase in the temperature in the

freezer compartment (for example due to

an earlier power failure) is indicated by

flashing the alarm icon and freezer

temperature indicators, and sounding of

buzzer.

Press any button.

The buzzer switches off.

The freezer temperature indicator shows

the highest temperature reached for a few

seconds, then displays the set

temperature again.

The alarm indicator continues

to flash until the normal

conditions are restored.

FastFreeze function

The FastFreeze function accelerates the

freezing of fresh food and, at the same

time, protects foodstuffs already stored

from undesirable warming.

1. To activate this function press the

Mode button until the corresponding

icon appears.

The FastFreeze indicator flashes.

2. Press the OK button to confirm.

TheFastFreeze indicator is shown.

This function stops automatically after 52

hours.

To switch off the function before its

automatic end repeat the procedure until

the FastFreeze indicator turns off.

The function switches off by

selecting a different set

temperature.

Door open alarm

If the door is left open for approximately

90 seconds, the acoustic alarm starts and

alarm indicator flashes.

The alarm stops after closing the door.

During the alarm, the acoustic signal can

be muted by pressing any button.

ChildLock function

Activate the ChildLock function to lock the

buttons from unintentional operation.

1. Press Mode until the corresponding

icon appears.

The ChildLock indicator flashes.

2. Press OK to confirm.

The ChildLock indicator is shown.

To deactivate the ChildLock function,

repeat the procedure until the ChildLock

indicator goes off.

20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Commentaires sur ces manuels

Pas de commentaire