Smeg SI5632D Manuel d'utilisateur télécharger pdf (Page 6)

Service

• To repair the appliance contact an

Authorised Service Centre.

• Use original spare parts only.

Disposal

WARNING! Risk of injury or

suffocation.

• Contact your municipal authority for

information on how to discard the

appliance correctly.

• Disconnect the appliance from the

mains supply.

• Cut off the mains electrical cable close

to the appliance and dispose of it.

INSTALLATION

WARNING! Refer to Safety

chapters.

Before the installation

Before you install the hob, write down the

information bellow from the rating plate.

The rating plate is on the bottom of the

hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in units

and work surfaces that align to the

standards.

Connection cable

• The hob is supplied with the connection

cable.

• Replace the damaged mains cable only

with the spare parts cable. Speak to

your local Authorised Service Center.

WARNING! All electrical

connections must be made by

a qualified electrician.

CAUTION! Do not drill or

solder the wire ends. This is

strictly forbidden!

CAUTION! Do not connect the

cable without cable end sleeve.

Two-phase connection

1. Remove the cable end sleeve from

black and brown wires.

2. Remove an insulation of the brown

and black cable ends.

3. Apply a new wire end sleeve of 1.5

mm² on each cable end. (special tool

required).

Cable cross section

N

L1

N

L

230V~ 400V 2~N

L2

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N

Green - yellow Green - yellow

6

1 2 3 4 5 6 7 8 9 10 11 ... 79 80

Commentaires sur ces manuels

Pas de commentaire