Smeg C9GVXI Manuel de service télécharger pdf (Page 13)

Instructions for the installer

5. FINAL OPERATIONS

4.7.2 Primary air adjustment for the oven burner

• Loosen the adjustment screw “A” of the air regulation sleeve.

• Turn the adjustment sleeve “B” to the position that corresponds to the

type of gas to be used according to the table below.

• Tighten the adjustment screw and restore the seals.

• When the operation is completed, reassemble the burner correctly.

NATURAL GAS G 30/31 (LPG) G 110 – TOWN GAS

X= 5 mm 10 mm 3 mm

After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the pan stands.

Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the

appliance with the one corresponding to the new gas. The label is inserted inside the pack together with

the nozzles.

5.1 Regulation of the hob burners minimum for natural gas

Light the burner and turn it to the minimum position . Extract the gas tap knob

and turn the adjustment screw at the side of the tap rod until the correct

minimum flame is achieved.

Refit the knob and verify that the burner flame is stable (turning the knob rapidly

from the maximum to the minimum position the flame must not go out). Repeat

the operation on all the gas taps.

For models with valves, keep the knob at minimum level for a few seconds to keep the flame lit and to

activate the safety device.

5.2 Regulation of the hob burners minimum for liquid gas

In order to adjust the minimum with liquid gas, the screw at the side of the tap rod must be tightened

clockwise all the way.

The bypass diameters for each individual burner are shown in paragraph “4.2 Burner and nozzle

characteristics table (60/70 cm. model);”. When the adjustment is completed, restore the sealing of the

by-passes with paint or other material.

5.3 Positioning and levelling the appliance (depending on the model)

After making the electrical and gas connections, level the appliance on the floor by means of its four

adjustable feet. For good cooking results, the appliance must be properly levelled.

Depending on the model you have purchased, the foot height adjustment range may vary from 70 to 95

mm and from 110 to 160mm. These heights refer to the distance between the highest point of the foot

(fixed part) and the lowest point (movable part which rests on the floor).

5.4 Adjustment of the oven burner minimum

Light the burner and turn it to the minimum position .

Extract the gas tap knob and turn the adjustment screw

at the side of the tap rod until the correct minimum

flame is achieved.

Refit the knob and verify that the burner flame is stable

(turning the knob rapidly from the maximum to the

minimum position the flame must not go out). Repeat

the operation on all the gas taps.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Smeg C9GVXI Manuel de service Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Smeg C9GVXI