Smeg SFR30 Manuel d'utilisateur télécharger pdf (Page 9)

Name W

Heating resistance 2300

TYPE AND SECTION OF POWER CABLES

2300 W

3 X 1.5 mm

(*)

ELECTRICAL COMPONENTS OUTPUT

MAINTENANCE

Before carrying out maintenance of any kind,

disconnect the appliance from the mains. All

maintenance must be carried out by authorized

personnel only.

6) PART REPLACEMENT

To replace components located inside the fryer the

resistance should be lifted up and secured in the

vertical position. Take out the oil kettle and loosen

the four screws that are under it (see fig. 8). The

work surface can now be detached from the

worktop giving access to all internal components.

To reassemble the work surface of the appliance

take care not to damage the power cables and

make certain that they are well positioned in the

guides along the side of the appliance.

Note: In the event the power cord is replaced,

the ground wire must be left longer than the

lead wires (fig. 10) and the instructions in the

paragraph "ELECTRICAL CONNECTIONS" must

be observed.

To reassemble the appliance repeat the steps

above in the reverse order.

7) TECHNICAL SPECIFICATIONS OF

ELECTRICAL COMPONENTS

To facilitate the task of the installer a table with

component specifications is included below.

Type of cable Total output Single-phase power supply

of appliance 230 - 240 V ~

Neoprene

H05 RN-F

FIG. 9

FIG. 10

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Smeg SFR30 Manuel d'utilisateur Page 9