Smeg CW400RSD Manuel d'utilisateur télécharger pdf (Page 13)



Once the program has finished the message “END”

appears on the display. The

led indicator remains

red.

Basket removal

By closing the door the last executed program is proposed again and the led indicator turns green

Note:

While the water in the boiler and in the Tank is heating up, the display may show the Tank resistance

and

boiler resistance

symbols.

8.3 PROGRAM SELECTION

PROGRAM DURATION(*)

P1 Brief about 1’

P2 Medium about 2’ ( crystals cycle )

P3 Long about 3’

Continuous from 0 to 10’

(*)The cycle durations indicated above are based upon a tri-phase connection with a 50°C hot water

supply.

Where a cold water supply is used, the duration of the cycle could increase in relation to the input water

temperature since the dishwasher is equipped with a constant temperature and pressure rinse system.

8.4 RESIN CYCLE (for models equipped with water-softeners)

Upon reaching the number of set cycles the message

“rig” appears flashing on the display for 10”; if a

subsequent cycle is performed, and the request is

ignored, the message reappears for 10” at the end of

every cycle.

When the machine is on with the Tank either full or

empty press the

button until the “rig” message

appears.

Open the door and remove the overflow. Close the

door again and hold down the

button to empty the

Tank and the boiler. The

drain led indicator will flash

until draining has been completed.

END

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Pas de commentaire

Smeg CW400RSD Manuel d'utilisateur Page 13