Smeg CW400RSD Manuel d'utilisateur télécharger pdf (Page 20)



11 PROBLEMS AND ANOMALIES (USER)

PROBLEM

POSSIBLE CAUSE POSSIBLE REMEDY

THE L1 LED INDICATOR DOES

NOT TURN ON

There is no electrical current Verify the electrical current connection.

THE WASH PROGRAM DOES

NOT START

The dishwasher has not finished

Wait for the led indicator to turn

red.

POOR WASHING RESULTS

Sprinkler wash holes are clogged

or encrusted

Disassemble and clean the sprinklers

(10.2 Periodic checks)

Detergent or rinse-aid insufficient

or not adequate

Verify detergent type and quantity.

Plates / glasses poorly positioned Arrange plates / glasses accordingly.

Low wash temperature

Verify the temperature shown on the

display, if below 50°C call Assistance.

Inadequate cycle setting

Increase the duration of the wash

cycle, particularly if dishes are very

dirty or contain partially dried residues.

RINSE INSUFFICIENT

Sprinkler nozzles clogged

Calcium encrustations in the

boiler

Verify the cleanliness of the nozzles

and the correct function of any

installed water softeners.

GLASSES AND SILVERWARE

ARE STAINED

Rinse-aid inadequate or not

dispensed correctly.

Water is of a hardness level

above 12°dF or contains many

dissolved salts

Verify the rinse-aid container and

ensure its adequacy for use with the

water supply. If the problem persists

contact assistance.

WATER IS PRESENT IN THE

TANK AFTER DRAINING

Drainage tube is positioned poorly

or is partially blocked

Verify that the dishwasher’s tube and

drain are not blocked and that the

drain is not in too high of a position;

see the connection diagram.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Smeg CW400RSD Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Smeg CW400RSD