Smeg DWI409C Manuel d'utilisateur télécharger pdf (Page 6)

Installation instructions

The dishwasher can also be connected to a hot water supply

not

exceeding 60°C

. Supplying the appliance with hot water cuts down the

washing time by approximately 20 minutes, but slightly reduces its

effectiveness. Make the connection to the domestic hot water supply

using the same procedure described for connecting to the cold water

supply.

DRAIN CONNECTION

Insert the dishwasher’s drain

hose into a drain pipe having a

diameter of at least

4 cm

, or

alternatively, place it inside the

kitchen sink using the plastic

support provided, taking care not

to crush or excessively bend the

hose. It is important to prevent

the hose from coming loose and

falling. For this purpose, the

plastic support is equipped with a

hole for tying it to the wall or

water tap.

The free end should be positioned at a height of between

30 and 100

and should never be submerged in water.

If a horizontal drain extension hose is used (for a maximum of 3 m) the

drain hose can be placed at a maximum height of

85 cm

from the

ground.

2.2 Electrical connection

Plug the power cord into a suitable electrical outlet, according to the

instructions given in chapter "1. Safety and operating instructions".

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

Smeg DWI409C Manuel d'utilisateur Page 6