Smeg ST0904 Manuel d'instructions télécharger pdf (Page 8)

Installation instructions

IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:

IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE

DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTACTS OF AT

LEAST 3.5MM. AFTER INSTALLATION THE DISCONNECTION DEVICE HAS

TO BE EASY TO REACH.

THE CONNECTION TO THE MAINS MUST BE CARRIED OUT BY A

QUALIFIED TECHNICIAN IN ACCORDANCE TO THE SCHEME SHOWN

BELOW AND THE REGULATIONS IN FORCE.

L = brown

N = blue

= yellow-green

In the event of damage to the supply cord, have it replaced by the an

Authorized Technical Service Centre in order to avoid any risk.

If this lamp needs changing, contact the manufacturer or an Authorised

Service Centre.

The lamp must be of the same type and have the same characteristics

as the one already installed (see dataplate next to the lamp holder).

WHEN CLEANING AND MAINTAINING THE APPLIANCE:

BEFORE CARRYING OUT ANY WORK, ALWAYS UNPLUG THE APPLIANCE

FROM THE ELECTRICAL SUPPLY OR SWITCH OFF THE ALL-POLE

DISCONNECTION DEVICE.

WARNING!

Some components inside the appliance are intentionally electrically live

even with the ON/OFF switch turned to off.

Before any repair operation, disconnect the appliance from the electrical

mains.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Pas de commentaire

Smeg ST0904 Manuel d'instructions Page 8