Table of Contents 19 1. Precautions for safety and use________________________ 20 2. Fitting the appliance in the top ________________________ 21 2
Instructions for the Installer 28 5.5 Reassembling the hob skin Reverse the procedure described in point “ 5.1 Removing the hob skin”. Fit the
Instructions for the Installer 29 6. Description of controls 6.1 The front panel All the hob's control and monitoring devices are placed to
Instructions for the User 30 7. Using the hob Check that the burners, flame diffuser rings and pan stands are fitted correctly. The project
Instructions for the User 31 Make sure that the pan stands are simply fitted over their burners, and are not left in a raised or tilted position; i
Instructions for the User 32 7.2 Lighting burners with safety device The burner it controls is shown next to each knob (the example here
Instructions for the User 33 7.4 Pan diameters BURNERS 1 Auxiliary 2 Semi rapid 3 Rapid 4 Ultra rapid min. and max. Ø (in cm) 7-18 10-24 18-
Instructions for the User 34 8. Cleaning and maintenance Before carrying out any operations, disconnect the appliance from the electricity supp
Precautions for Safety and Use 20 1. Precautions for safety and use THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE OF IT AND
Instructions for the Installer 21 2. Fitting the appliance in the top The procedures required below must be carried out by a skilled builder
Instructions for the Installer 22 2.2 Fitting the gasket Fit the insulating gasket provided carefully around the outside edge of the hole made i
Instructions for the Installer 23 3. Electrical connection Check that the power supply line voltage and size are as specified on the nameplate u
Instructions for the Installer 24 4. Gas connection If the appliance is installed above an oven, the gas hose must be passed around the back of
Instructions for the Installer 25 5. Adapting to different types of gas The operations described below must be carried out with the appliance not
Instructions for the Installer 26 5.2 Adjusting for bottled gas Undo the screw C and push the air regulator D fully down. Remove the nozzle E wi
Instructions for the Installer 27 5.3 Adjusting for natural gas The appliance is tested with G20 (2H) natural gas at the pressure of 20 mbar. To r
Commentaires sur ces manuels