Smeg A31X-6 Manuel d'utilisateur télécharger pdf (Page 6)

Instructions for the Installer

2.3 Gas connection

This appliance is suitable for installation with Natural

Gas or ULPG (propane). Refer to page 12 for the

relevant burner pressure and appropriate injector sizes.

When the appliance is to be connected to Natural Gas

then the pressure regulator supplied must be fitted to the

gas inlet. A test point (for checking the gas pressure) is

supplied either with the regulator or as a separate fitting

in the case of ULPG (propane) appliances.

Connection of the appliance to the gas supply must be in

accordance with the requirements of AS5601. A ½” BSP

connector at the inlet is recommended and the gas

supply line to the appliance must be of adequate length

to allow sufficient withdrawal of appliance for service or

disconnection and be:

1. annealed copper pipe or;

2. flexible hose according to AS/NZ1869 & be at least

Class “B”, 10 mm diameter.

The cooker must be installed with provision to allow the gas to be turned

off and disconnected for servicing and removal of the appliance as

required from the gas supply.

Before the cooker is operated make certain all relevant parts are placed

in the correct position.

When the installation is completed the installation connections of cooker

will require to be leak tested, the burner operating pressure and flame

checked and adjusted.

Warranty service calls do not cover these adjustments!

To check the operating pressure of the appliance it is recommended at

least 2 large size burners are used. Ensure appliance is secured to wall

when installation is completed.

N.G. The regulator supplied must be fitted to the ½ BSP thread at the

rear of the appliance. An approved manual shut-off valve must be

installed. The N.G. regulator must be checked and adjusted to 1.0kPa

after installation.

ULPG: Can be connected to the inlet fitting

directly. The pressure must be checked to

ensure it is operating at 2.75kPa. A separate

test point fitting must be installed between the

piping & the appliance for the pressure to be

checked to ensure it is operating at 2.75kPa.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Pas de commentaire

Smeg A31X-6 Manuel d'utilisateur Page 6