Smeg SC321N Manuel d'utilisateur télécharger pdf (Page 20)

Instructions for the installer

13.2 Positioning the oven

The oven is designed for mounting into any piece of furniture as long as it

is heat-resistant. Proceed according to the dimensions shown in Figures

1, 2 and 3. For installing under a work top, follow the dimensions given in

Figure 1-3. When installing under worktops incorporating combined hobs,

a gap of at least 110 mm must be left from any side wall, as shown in

figure 1.

When installing in tall units, comply with the dimensions shown in figure 1-

2, bearing in mind that the top/rear of the unit must have an opening 80-90

mm deep. Tighten the 4 screws A inside the frame (fig. 1). For installing

beneath a non-integrated top, allow for a rear and bottom clearance as

shown in Figure 1 (ref. B). See relevant instructions for fitting and securing

the hob.

Never use the oven door to lever the oven into

place when fitting. Avoid exerting too much

pressure on the oven door when open.

1 2 ... 15 16 17 18 19 20

Pas de commentaire

Smeg SC321N Manuel d'utilisateur Page 20