Smeg FA550XBI2 Guide de dépannage télécharger pdf (Page 4)

In case of power failures of up to 24 hours

Keep the doors of the appliance closed. In this way the stored food will stay cold as long as possible. For

further information see chapter “Using the appliance”, section “Black-out alarm”.

If the appliance is not going to be used

- Disconnect the appliance from the power supply.

- Remove all the food if you are going away for more than three weeks.

- If the appliance has an automatic ice-maker:

1. Shut off the water supply to the automatic ice-maker.

2. Empty the ice bucket.

- Leave the doors open enough for air to circulate inside the compartments. This will prevent the

formation of mould and bad odours.

IF THE APPLIANCE IS NOT GOING

TO BE USED

Before any cleaning or maintenance operation, always disconnect

the appliance from the power supply.

• Periodically clean the appliance with a cloth and a solution of

lukewarm water and neutral detergent specific for refrigerator

interiors.

• Never use detergents or abrasives. Never clean the refrigerator

parts with flammable liquids. The fumes can cause fires or

explosions.

• Clean the outside of the appliance and the door seals with a

damp cloth and dry with a soft cloth.

• Do not use steam cleaners.

• Clean the condenser using a vacuum cleaner, remove the front

kickplate (see installation handbook).

• The buttons and control panel display (located on the freezer

door on some models) must be cleaned with a dry cloth; do not

use alcohol or alcohol-derived substances.

• The refrigerant system pipes are located near the defrost pan

and can become very hot. Periodically clean them with a vacuum

cleaner.

Replacing light bulbs

Attention

• Always disconnect the refrigerator from the power supply

before replacing any light bulbs.

• Before replacing the light bulb, remove the light guard that may

be present. This will have to be put back after replacing the light

bulb.

• The refrigerator accepts light bulbs with a bayonet type mount.

These do not need unscrewing/screwing when replacing.

• The ice/water dispenser light bulb has a standard screw type

mount and therefore needs to be screwed in place.

Replace the lamp with one of the same type, available from the

After-sales Service or from authorised dealers.

MAINTENANCE AND CLEANING

1 2 3 4 5 6 7 8 9 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Smeg FA550XBI2 Guide de dépannage Page 4

Commentaires sur ces manuels