Smeg S800TL1 Manuel d'utilisateur télécharger pdf (Page 20)

“Rinse Hold” button

• The laundry remains in the last rinse water without

progressing to the final spin cycle to avoid creasing

and prevent colours from fading.

• This option is particularly recomended for the

“Synthetic” and “Delicate” programmes.

• This function is particularly useful if you want to

postpone spinning to a later time, or if you want to

drain only.

Note: the programme selector knob stops on .

Appliance in “Rinse Hold”:

• Press the “Rinse Hold” button again: the programme

will terminate automatically with the selected spin

cycle.

• If you do not wish to spin the clothes, press the

“On/Off” button, turn the programme selector

knob to the “Drain” programme and press the

“On/Off” button again.

5019 612 10072

Programme

Temperature

selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

Cotton

95 5,0 63* 1,80 2:05

Cotton

60 5,0 55 0,95 2:05

Cotton

40 5,0 55 0,55 2:05

Synthetic

60 2,0 56 0,80 1:30

Synthetic

40 2,0 56 0,40 1:30

Delicate

40 1,5 60 0,55 0:45

Wool

40 1,0 60 0,50 0:40

Silk

30 1,0 60 0,30 0:50

1. Load the machine, close the drum doors and check

that they are properly locked.

2. Add detergents and additives into the dispenser to

no more then the “MAX” level mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softener and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the programme selector knob to the

desired programme.

4. Turn the temperature selector knob to the

desired temperature.

5. Turn the spin speed selector knob to the

desired spin speed. If the spin speed “0” is selected,

the final spin is cancelled, but not the intermediate

spins. The programme ends with a drain cycle.

CONSUMPTION DATA

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized

conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in

the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the

water out.

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

PROGRAMME START

Turn on the tap and press the “On/Off” button.

The indicator light of the “On/Off” button lights up.

Note: If there is a power interruption or if the appliance

is disconnected during the cycle, the programme will run

again from the point where it was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop position.

1. Press the “On/Off” button to switch off the

machine.

2. Cancel the options.

3. Turn the tap off.

4. Wait for the lid to unlock (about 1 minute).

5. Open the lid and the drum doors and unload the

machine.

CHANGE THE PROGRAMME DURING THE

WASH CYCLE

1. Switch off the machine by pressing the “On/Off”

button.

2. Select the new programme.

3. Start programme by pressing the “On/Off” button

again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme

for a certain time and continue it later:

1. Press the “On/Off” button.

2. After the desired pause, press again the “On/Off”

button.

CANCEL PROGRAMME

1. Switch off the machine by pressing the “On/Off”

button.

2. Set the programme selector to “Drain”.

3. Press the “On/Off” button again to start the

“Drain” programme.

Selecting or deselecting an option can be done at

any time during the programme. The option will be

applied as long as the corresponding programme

phase has not been executed yet.

“Rapid” button

• For fast, energy saving wash cycles.

• Ideally suited for small loads consisting of lightly

soiled laundry.

“Half Load” button

• Can be used for small loads and lightly soiled laundry.

• Reduces the water consumption especially during

the rinses.

“Intensive Rinse” button

• The amount of water is increased to ensure a more

intensive rinse.

• This option is particularly suitable for areas with very

soft water or washing linen laundry for people with

skin allergies.

1 2 ... 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Smeg S800TL1 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Smeg S800TL1