Smeg SUK92CMX9 Manuel de service télécharger pdf (Page 26)

Instructions for the user

10.5 Removing the internal glass panels

The glass in the door should always be kept thoroughly clean. To facilitate cleaning, it is possible to

remove the door (see 10.3 Removing the door) and place it on a canvas, or open it and lock the hinges

in order to extract the glass panels. The glass panels of the door can be completely removed by following

the instructions provided below.

before removing the glass panels, make sure that at least one of the door's hinges has been locked in

the open position as described in chapter “10.3 Removing the door”. This operation may have to be

repeated during the glass removal process if the door is accidentally freed.

Removing the internal glass panel:

• Remove the internal glass panel by pulling the rear part

gently upwards, following the movement indicated by the

arrows (1).

• Then pull the front of the glass panel upwards (2).

• Doing this detaches the 4 pins attached to the glass from

their slots in the oven door.

Removing the middle glass panels:

• (pyrolitic models) there are two middle glass panels

attached using 4 small locks. Remove the middle panels by

lifting them upwards.

• (other models) a middle glass panel may be present; if so,

remove it by lifting it upwards.

Cleaning:

• It is now possible to clean the external glass panel and the

panels removed previously. Use absorbent kitchen roll. In

case of stubborn dirt, wash with a damp sponge and neutral

detergent.

Replacing the glass panels:

• Replace the panels in the reverse of the order in which they

were removed.

• Reposition the internal glass panel, taking care to centre

and insert the 4 pins attached to the glass into their slots in

the oven door by applying slight pressure.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Smeg SUK92CMX9 Manuel de service Page 26