Smeg ALFA135BV Manuel d'instructions télécharger pdf (Page 4)

Instructions for the installer

2. INSTALLATION OF THE OVEN

The oven must be set up on a perfectly flat surface and left standing

free. Make sure to allow enough room at the back for easy access to the

terminal strip for connection of the power cable to mains.

Installation must be carried out by a qualified technician in compliance

with applicable regulations in force.

2.1 Electrical connection

Make sure that the power line voltage matches the specifications

indicated on the rating plate located to the rear of the oven. This rating

plate must never be removed.

The oven is equipped with a power

converter which is designed to adapt

power input to local current rating.

The converter is factory-set at 3850W.

If required, this value may be

increased by adjusting the switch at

the rear of the oven by means of a

screwdriver.

MIN = Minimum power (3850W).

MED = Medium power (4250W).

MAX = Maximum power (5500W).

The connection terminals are

located at the rear of the

appliance. For electrical

connections see following

diagram. For access to the

terminal board, remove the

door located at the back of

the oven.

1 2 3 4 5 6 7 8 9 ... 15 16

Pas de commentaire

Smeg ALFA135BV Manuel d'instructions Page 4