Smeg CS71-5 Manuel de service

Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 32 2. INSTALLATION OF THE APPLIANCE ______________________________ 34 3. A

Instructions for the user 40 OVEN THERMOSTAT KNOB Selection of cooking temperature is carried out by turning the knob clockwise to the required tem

Instructions for the user 5.2 Electronic Analogue Clock LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC SWITCH-OFF TIMING BUTTON TIME

Instructions for the user 42 5.2.2 Minute-minder This function does not stop cooking but just triggers the beeps. - When the key is pressed the

Instructions for the user 5.2.3 Programming Cooking duration time: the 2nd button can be used to set the cooking time. Before setting it, turn

Instructions for the user 44 Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hour

Instructions for the user 6. USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame

Instructions for the user 46 7. USE OF THE OVEN 7.1 Warnings and general advice Before using the oven for the first time, pre-heat it to maximum t

Instructions for the user 8. AVAILABLE ACCESSORIES The main oven has 4 support for positioning plates and racks at various heights and has uppe

Instructions for the user 48 9. COOKING HINTS During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pa

Instructions for the user 9.2 Hot-air grilling FUNCTION SWITCH THERMOSTAT SELECTOR SWITCH FROM 50° TO 230°C VARIABLE GRILL CHOICE B

Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY A

Instructions for the user 50 9.4 Traditional cooking FUNCTION SWITCH THERMOSTAT SELECTOR SWITCH FROM 50° TO 250°C This tradi

Instructions for the user 9.6 Spit cooking FUNCTION SWITCH THERMOSTAT SELECTOR SWITCH FROM 50° TO 250°C THERMOSTAT SELECTOR SW

Instructions for the user 52 10. CLEANING AND MAINTENANCE Before performing any operations requiring access to powered parts, switch off the po

Instructions for the user 10.2.2 Burner caps and flame cap crowns The caps and flame-spreader crowns are extractable to facilitate cleaning. Was

Instructions for the user 54 10.3.2 Using the self-cleaning liners Periodically, to prevent food residues and unpleasant smells fromaccumulating i

Instructions for the user 11. EXTRAORDINARY MAINTENANCE Ovens periodically require small maintenance interventions or replacement of parts subje

Instructions for the user 56 11.2 Removing the door Open the door completely and fit the pins (supplied) into the holes from the inside. Close t

Introduction THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS POSITIONED VISIBLY IN THE STORAGE COMPARTMENT. THE PLATE MUST

Instructions for the installer 34 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Cor

Instructions for the installer 2.2 Ventilation requirements The room containing the appliance should have an air supply in accordance with B.S. 5

Instructions for the installer 36 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the applianc

Instructions for the installer 3.2 Burner and nozzle characteristics table Rated Burner heating capacity (kW) LPG – G30/G31 28/37 mbar N

Instructions for the installer 38 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the

Instructions for the user 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel.