Smeg SUK92MFX5 Manuel de service télécharger pdf (Page 19)

Instructions for the installer

15.FINAL OPERATIONS

After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids.

Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the

appliance with the one corresponding to the new gas. This label is in the packet together with the

nozzles.

15.1 Regulation of the hob burner minimum level for natural gas

Light the burner and turn it to the minimum position .

Remove the knob and turn the regulation screw inside or next to the gas tap pin

(depending on the model) until you get a suitable minimum flame. Replace the

knob and check burner flame stability: (rapidly turning the knob from maximum to

minimum position, the flame should not go out). Repeat the operation on all the

gas taps.

For models with valves, keep the knob at minimum level for about 1 minute to keep the flame lit and to

activate the safety device.

15.2 Regulation of the hob burner minimum level for LPG

In order to adjust the minimum with LPG, the screw at the side of the tap rod must be turned clockwise all

the way.

The bypass diameters for each individual burner are shown in paragraph “14.2 Burner and nozzle

characteristics table". Once the regulation has been completed, restore the seal on the by-passes using

paint or similar materials.

15.3 Mounting the rear top skirtboard (where applicable)

• Loosen nuts B.

• Position the skirt above the top, taking care to align pins C with

holes D.

• Secure the skirt to the top by tightening screws A.

15.4 Wall fixing

• Stretch out the chain attached to the cooker horizontally so that

the other end touches the wall.

• Mark the wall in the position where the hole is to be drilled.

• Drill the hole, insert a wall plug and attach the chain.

• Move the cooker up against the wall.

1 2 ... 14 15 16 17 18 19 20

Pas de commentaire

Smeg SUK92MFX5 Manuel de service Page 19