Smeg SFR30 Manuel d'utilisateur télécharger pdf (Page 7)

4) SECURING THE FRYER

To secure the fryer to the worktop the fastening

clamps accompanying this booklet must be

assembled. The following procedures must be

carried out to do this:

· remove all movable parts from the fryer;

· turn the appliance over taking care to place it on

a soft surface to avoid damaging the external

surfaces;

· remove the clamps "G" from the package and

install them as in the diagram in fig. 6.

After these steps have been carried out, the

special gasket that prevents liquids from leaking

can be installed. To fit this gasket correctly, please

strictly follow the directions below:

- detach the gasket strips from their support

taking care that the transparent protection

remains attached to the gasket;

- put the gasket "E" (fig. 6) in the correct position

under the edge of the worktop, so that the outer

side of the gasket fits perfectly with the external

perimeter of the worktop. The ends of the strips

must fit without overlapping;

- make sure the gasket adheres to the worktop

evenly all around, press it down with your

fingers, then remove the gasket's protection

paper and position the fryer in the opening made

in the worktop;

- secure the appliance by tightening the clamp

screws "F" (see fig. 7).

WARNING:

Note that the adhesive which joins the plastic

laminate to the worktop must be resistant to

temperatures of no less than 150°C to prevent the

covering from detaching.

The installer is advised that the rear wall,

adjoining and surrounding surfaces of the fryer

must be resistant to a temperature of 75 K.

INSTALLATION

ABCD

FRYER

285 485 60 60

USEFUL MEASUREMENTS

(mm)

FIG. 6

FIG. 7

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Smeg SFR30 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Friteuses Smeg SFR30