Smeg S7323LFLD2 Manuel d'utilisateur télécharger pdf (Page 31)

2. Remove the door.

3. Remove the lower spacer.

4. Loosen the lower pin with a key.

5.

Tighten the lower pin on the opposite

side.

6. Install the lower spacer.

7. Install the door.

8. Tighten the spacer and the upper pin.

Do a final check to make sure

that:

• All screws are tightened.

• The magnetic seal adheres to

the cabinet.

• The door opens and closes

correctly.

If the ambient temperature is

cold (i.e. in Winter), the gasket

may not fit perfectly to the

cabinet. In that case, wait for the

natural fitting of the gasket.

In case you do not want to carry

out the above mentioned

operations, contact the nearest

Authorised Service Centre. The

Authorised Service specialist will

carry out the reversibility of the

doors at your cost.

Installing the appliance

CAUTION! Make sure that the

mains cable can move freely.

1. If necessary cut the adhesive sealing

strip and then apply it to the appliance

as shown in figure.

x

x

2.

Install the appliance in the niche.

3.

Push the appliance in the direction of

the arrows (1) until the upper gap cover

stops against the kitchen furniture.

1

2

4. Push the appliance in the direction of

the arrows (2) against the cupboard on

the opposite side of the hinge.

5. Adjust the appliance in the niche.

Make sure that the distance between

the appliance and the cupboard front-

edge is 44 mm.

31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Commentaires sur ces manuels

Pas de commentaire