Smeg A21A0XXAA Manuel d'utilisateur télécharger pdf (Page 5)

Instructions for the installer

2.2 Fixing the flush-top model to the structure.

dimensions shown in the figure in the top surface of the counter,

keeping a minimum distance of 50 mm from the rear border.

This appliance is classified as “type Y” in relation to fire hazards and

can therefore be mounted against walls higher than the work surface

on condition that a certain distance “X” be kept between the appliance

and the wall as shown in the figure so as to avoid damage from

overheating.

Make sure there is a minimum of 750 mm between the hot plate flames

and any shelf that may be installed directly above them.

This type of appliance also requires a cut 2 mm deep in the worktop of the

size shown in figure 3. Before putting the worktop in place, fit the gasket

right around the perimeter of the appliance and make sure that it fits

snugly against the metal.

Thegasketmustbefittedasshowninfigure5.

The appliance can also be installed using silicone instead of the gasket

supplied. In this case, the installer is responsible for ensuring that the

appliance is perfectly level with the top of the unit.

2.3 Electrical connection

Make sure that the voltage and capacity of the power line conform to the

data shown on the plate located under the casing. Do not remove this

plate for any reason.

The plug on the end of the supply cable and the wall socket must be the

same type and conform to the current electrical system regulations.

Check that the power line is adequately grounded.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Smeg A21A0XXAA Manuel d'utilisateur Page 5