Smeg 142396 Manuel d'utilisateur télécharger pdf (Page 8)

142396

Required tools; socket spanner nr. 8,

screwdriver, torx 25

Caution! After unscrewing of before ﬁ xing hinges,

hold the door to prevent it from falling and

damaging.

1. Remove upper hinge cover (keep it for eventual

later use), together with cover on the opposite

side of the upper hinge cover (on the opposite

side you will insert the attached cover during the

assembly), and remove the cover on the opposite

side of the upper part of the door.

2. Unscrew upper hinge screws and remove the

door from the bottom hinge.

3. On the bottom side of the door unscrew the

swing stopper screws and remove the stopper

(A) keep this stopper for later use. Fix the

attached stopper with its bearing on the opposite

side of the door.

4. Unscrew the forced door closure system (B)

and ﬁ x it to the opposite side of the door (certain

models only).

5. Remove handle screw covers, unscrew handle

screws, and remove plastic pegs on the opposite

side.

6. Tilt the appliance backward (max. 35°) to lean

to the rear side of the cabinet. Unscrew the leg

support screws (C) - left and right, and remove

the leg support cover (D). Unscrew and remove,

then reciprocally replace the position of end

switch (E) and decorative peg (F) (for models

with forced door closing system). Place this on

opposite side. Unscrew three screws ﬁ xing the

bottom hinge (keep the hinge for later use), and

ﬁ x the attached bottom hinge on the opposite

side.

7. Proceed with the assembly procedure in opposite

sequence.

Reverse door swing

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Smeg 142396 Manuel d'utilisateur Page 8