Smeg A2PY-6 Manuel de service télécharger pdf (Page 7)

Instructions for the Installer

3. ADAPTING TO DIFFERENT TYPES OF GAS

Before carrying out the operations described below, disconnect the

appliance from the electricity supply.

The appliance is tested with G20 (2H) natural gas at the pressure of 20

mbar. If it is to be used with other types of gas, the burner nozzles have

to be changed and the gas tap adjusted to set the minimum flame. To

replace the nozzles, proceed as described below.

3.1 Changing the hob nozzles

1. Remove the pan stands, all the burner caps and the flame diffuser

rings;

2. Use a 7 mm socket wrench to unscrew the burner nozzles;

3. Replace the burner nozzles depending on the type of gas to be used (see

point “3.2 Burner and nozzle characteristics table").

Put the burners back into place correctly.

Nozzles for the use of town gas (G110 – 8 mbar) are available from

authorised service centres.

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Pas de commentaire

Smeg A2PY-6 Manuel de service Page 7