Smeg A2PY-6 Manuel de service télécharger pdf (Page 9)

Instructions for the Installer

4. FINAL OPERATIONS

After changing the nozzles, put the pan stands, the burner caps and

flame diffuser rings back in place.

After adjusting for use of a gas other than the gas used for testing the

appliance, replace the gas setting label inside the storage compartment

with the label for the new gas. The label is available from your nearest

Authorised Service Centre.

4.1 Adjusting the minimum setting for town gas and natural

gas

Light the burner and turn it to the minimum setting

. Remove the gas tap knob and adjust the

regulator screw inside or beside the tap rod

(depending on the model) until an even minimum

flame is obtained. Put the knob back in place and

check the stability of the burner flame (the flame

must not go out when the knob is turned quickly

from the maximum to the minimum setting). Repeat

the operation on all the gas taps.

4.2 Adjusting the minimum for bottled gas

The diameters of the bypasses for each individual burner are stated in

point "3.2 Burner and nozzle characteristics table". When the adjustment

is complete, re-seal the bypasses with paint or another similar material.

4.3 Positioning and levelling the appliance

After making the electrical and gas connections, level the appliance by

means of its four adjustable feet.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Pas de commentaire

Smeg A2PY-6 Manuel de service Page 9