Smeg A2BL-8 Manuel d'utilisateur télécharger pdf (Page 41)

Installation

87

EN

Fixed connection

Fit the power line with an omnipolar circuit

breaker in compliance with installation

regulations.

The circuit breaker should be located near

the appliance and in an easily reachable

position.

Connection with plug and socket

Make sure that the plug and socket are of

the same type.

Avoid using adapters and shunts as these

could cause overheating and a risk of

burns.

5.4 Positioning

General information

This appliance may be installed next to

walls, one of which must be higher than the

worktop, at a minimum distance of 150 mm

from the side of the appliance, as shown in

figures A and C relative to the installation

classes.

The values indicated above refer

to the cross-section of the internal

conductor.

The aforementioned power cables

are sized taking into account the

coincidence factor (in compliance

with standard EN 60335-2-6).

Heavy appliance

Danger of crushing injuries

• Position the appliance into the cabinet

cutout with the help of a second person.

Pressure on the open door

Risk of damages to the appliance

• Never use the oven door to lever the

appliance into place when fitting.

• Avoid exerting too much pressure on the

oven door when open.

Heat production during appliance

operation

Risk of fire

• Veneers, adhesives or plastic coatings

on adjacent furniture should be

temperature-resistant (no less than

90°C).

1 2 ... 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire