Smeg SUK62CMX8 Manuel de service télécharger pdf (Page 18)

Instructions for the user

9.5 Cleaning the oven

For the best oven upkeep, clean it regularly after having allowed it to cool. Take out all removable parts.

• Clean the oven racks with hot water and non-abrasive

detergent. Rinse and dry.

• For easier cleaning, the door can be removed (see

“10.3 Removing the door”).

The oven should be operated at the maximum heat setting for 15/20 minutes after use of specific

products, to burn off the residues left inside the oven.

When the operation is complete, damp parts should be dried thoroughly.

9.5.1 Removing guide frames

Removing the guide frames and the self-cleaning panels

enables the sides to be cleaned more easily. This operation

should be carried out each time the automatic cleaning

cycle is used (on some models only).

To remove the guide frames:

1 Pull the frame towards the inside of the oven to unhook

it from its housing A, then slide it out of the seats at the

back B.

2 When cleaning is complete, repeat the above

procedures to put the guide frames back in.

9.5.2 Cleaning the door glazing

The glass in the door should always be kept thoroughly clean. Use absorbent kitchen roll; remove

stubborn dirt with a damp sponge and an ordinary detergent.

Do not use abrasive or corrosive detergents to clean the oven's door glass panels (e.g. powder products,

spot-removers and wire sponges). Do not use rough or abrasive materials or sharp metal scrapers to

clean the oven's glass doors since they may scratch the surface.

9.5.3 Cleaning the door seal

To keep the seal clean, use a non-abrasive sponge and lukewarm water. The seal should be soft and

flexible (with the exception of pyrolitic models).

In pyrolitic models, the seal may flatten over time and lose its original shape. To restore it, pinch the seal

all the way along. This also helps remove any dirt on the seal.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Pas de commentaire

Smeg SUK62CMX8 Manuel de service Page 18