Smeg SY92IPBL8 Manuel de service télécharger pdf (Page 32)

Instructions for the installer

• Use H05V2V2-F cables resistant to at least 90°C.

• The values indicated above refer to the cross-section of the internal conductor.

• The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm.

• The aforementioned power cables are sized taking into account the coincidence factor (in compliance

with standard EN 60335-2-6).

11.4 Positioning the skirt

WARNING: The skirt provided is an integral part of the product; it must be fastened to the

appliance prior to installation.

The skirt must always be positioned and secured correctly on

the appliance.

1 Loosen the 4 screws (A) on the back of the worktop (2 for

each side).

2 Place the skirt above the worktop, taking care to align the

skirt's slots (B) with the screws (A).

3 Secure the skirt to the worktop by tightening screws (A).

11.5 Positioning and levelling the appliance

After making the electrical and/or gas connections, level the

appliance on the floor by means of its four adjustable feet.

Insert the front feet first and then the rear ones.

The appliance must be properly levelled to ensure better

stability. Screw or unscrew the bottom part of the foot until the

appliance is stable and level on the floor.

To prevent possible damage to the appliance, we recommend to screw the front feet first and then the

rear ones.

1 2 ... 27 28 29 30 31 32

Pas de commentaire

Smeg SY92IPBL8 Manuel de service Page 32