Smeg CH300 Manuel d'utilisateur télécharger pdf (Page 10)

10

GB

Cleaning and maintenance

Cleaning

Before cleaning, disconnect the power sup-

ply and remove all loose ttings.

The cabinet is best cleaned using warm

water (max. 65 °C) with a little mild,

perfume-free detergent. Never use cleaning

agents that scour. Use a soft cloth. Rinse

with clean water and dry thoroughly. It is

important to prevent water from entering the

control panel.

The sealing strip around the lid must be

cleaned regularly to prevent discolouration

and prolong service life. Use clean water.

After cleaning the sealing strip, check that it

continues to provide a tight seal.

The ventilation grille must be kept free

of dust and dirt. Clean it with a vacuum

cleaner.

If the appliance is not to be used for any

length of time, switch it off, disconnect the

power supply, empty it, clean the cabinet

and leave the lid open to allow air circula-

tion and prevent smells.

Replacing the bulb

1. Disconnect the power supply by pulling

the plug out of the socket.

2 . Remove the lamp cover by pressing its

upper edge downwards to release it from

the two clips (g. 7).

3. Replace the bulb(s).

4. Ret the cover and reconnect the power

supply.

max.

15 W

g. 7

Advise for minimising the energy consumption

● The lower ambient temperature the lower

energy consumption.

● The lower temperature inside the unit the

higher energy consumption.

● Recommended temperature -18°C

● Defrost when the ice build-up is more

than 5 mm thick.

● Do not open the lid more than necessary.

● Cool hot food and beverages before plac-

ing them in the freezer.

● Thaw frozen items in a refrigerator.

● Place frozen items in a refrigerator while

defrosting the freezer.

1 2 ... 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire