Smeg PVA750D Manuel d'utilisateur télécharger pdf (Page 11)

Instructions for the Installer

5.5 Reassembling the hob skin

Reverse the procedure described in point “5.1 Removing the hob skin”.

When replacing the cover plates, check that the seals are fitted correctly.

7.1Fit the pan stands as described in point Fitting the pan stands.

5.6 Adjusting the minimum setting for natural ga

Reassemble the components on the burner and fit the

knobs onto the tap rods.

Light the burner and turn it to the minimum

setting.

Remove the knob again and adjust the regulator

screw inside or beside the tap rod (depending on the

model) until an even minimum flame is obtained.

Put the knob back in place and check the stability of

the burner flame (the flame must not go out when the

knob is turned quickly from the maximum to the

minimum setting).

5.7 Adjusting the minimum for bottled gas

To adjust the minimum level when using bottled gas, the adjuster screw inside or

beside the tap rod must be turned fully clockwise (depending on the models).

The diameters of the bypasses for each individual burner are stated in point “5.2

Adjusting for bottled gas".

After adjusting for use of a gas other than the gas used for testing the appliance,

replace the label on the casing with the label for the new gas. The label is supplied in

the bag with the LPG nozzles (G30 - G31).

5.8 Hob burner layout

Burner type

1 Auxiliary

2 Semi rapid

3 Rapid

4 Ultra rapid

5.9 Greasing the gas taps

Over time, the gas taps may become stiff or jam. Clean their insides and change their

lubricating grease. This operation must be carried out by a skilled technician.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Smeg PVA750D Manuel d'utilisateur Page 11