Smeg PVA750D Manuel d'utilisateur télécharger pdf (Page 9)

Instructions for the Installer

5.2 Adjusting for bottled gas

Undo the screw C and push the air regulator

D fully down.

Remove the nozzle E with a 7 mm spanner

and fit the suitable one, following the

instructions in the tables referring to the type

of gas to be used. The nozzle must not be

tightened with a torque of more than 3 Nm.

Regulate the air flow by sliding the regulator D

along until the distance “X” stated in point "5.5

Adjusting the primary air flow” is obtained.

Fix the regulator D by tightening the screw C.

Burner

Rated

heat

capacity

(kW)

Bottled gas – G30/G31 30/37 mbar

Nozzle

diameter

1/100 mm

By-pass

1/100

Reduced

heat

capacity

(W)

Flow

rate g/h

G30

Flow

rate g/h

G31

Auxiliary 1.05 48 30 400 76 75

Semi rapid 1.7 62 32 450 124 121

Rapid 3.0 80 1050 218 214 50

Ultra Rapid 5.0 108 63 1600 363 357

5.3 Adjusting for natural gas

The appliance is tested with G20 (2H) natural gas at the pressure of 20 mbar. To return the

appliance to the condition required to use this type of gas, proceed as described in point “5.2

Adjusting for bottled gas” but select the nozzles and adjust the primary air flow for natural gas,

as indicated in the table below and in point “5.5 Adjusting the primary air flow”.

Rated heat

Burner

Capacity (kW)

Natural gas - G20 20 mbar

Nozzle diameter Reduced heat capacity

1/100 mm (W)

Auxiliary 1.05 73 400

Semi rapid 1.7 92 450

Rapid 3.0 123 1050

Ultra Rapid 5.0 165 1400

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

Smeg PVA750D Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Smeg PVA750D