Smeg S45MX2 Manuel de service télécharger pdf (Page 14)

GB-IE

Instructions for the User

 Press PT1 to activate the parameter modification mode. The

symbol starts to blink. Turn PT1 to the right or left to change the

remaining cooking duration.

 Press PT1 to validate and the next parameter light starts to blink.

Proceed as described in the active function chapter to modify the

remaining parameters.

 Press PT2 to continue the cooking process.

7.5.3 Cancelling a cooking cycle

If you wish to cancel the cooking process, press PT2 for 3 seconds.

You will then hear a beep and the oven returns to the OFF setting.

7.5.4 End of a cooking cycle

At the end of the process you will hear three beeps and the display will

show the word “End”.

The beeps are repeated every 30 seconds until the door is opened or PT2

is pressed. The oven returns to the OFF setting.

7.6 Secondary menu

This appliance also has a concealed "secondary menu" allowing the user

to:

1. Activate or deactivate the Show Room function (which disables all the

heating elements so that only the control panel works);

2. Activate or deactivate the function which limits the maximum power

absorption to 2300 W;

3. Activate or deactivate the child safety device ( );

7.6.1 Show Room Function

With the oven in OFF status (see point “7.2 Operating settings”) keep PT1

pressed until the message OFF SHO appears on DSP1. This means that

the SHOW ROOM function (which disables all the heating elements so

that only the control panel works) is not active.

Turn PT1 to the right or left to activate (ON SHO) or deactivate (OFF SHO)

this function. To use the oven normally, set OFF SHO.

After setting the parameter required, press PT2 to return the oven to the

initial standby status.

7.6.2 Power selection function

This function allows the oven operation if there are limitations in the mains

power (e.g. 3 kW for Italian market). The cooking results will not be

affected but the cooking duration will be increased on some functions that

activated more than one heating element.

With the oven in OFF status (see point “7.2 Operating settings”) keep PT1

pressed until the message OFF SHO appears on DSP1. Now press PT1

once again and the message “OFF 2000” will appear on DPS1.

Turn PT1 to the right or left to activate (ON 2000) or deactivate (OFF

2000) this function, which limits the oven's maximum power absorption, in

any function, to 2000 W.

After setting the parameter required, press PT2 to return the oven to the

initial standby status.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Smeg S45MX2 Manuel de service Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Smeg S45MX2