Smeg STFABUWH Manuel d'installation télécharger pdf (Page 19)

Connecting to a “T” union of the drain circuit



MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE

DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR

ON WHICH THE DISHWASHER WILL BE INSTALLED.

Connect the dishwasher drain hose (ref. A ﬁ g. 5-10) to the “T” union (ref. B

ﬁ g. 5-10) of the drain circuit using a 38 to 50 mm (1-1/2 to 2”) screw clamp*

(ref. C ﬁ g. 5-10); if necessary, cut the end of the dishwasher drain hose (ref.

D ﬁ g. 5-10) (do not cut the corrugated section).

* Available from any plumbing stockist

Fig. 5-10

Connecting to a waste disposal unit with an air gap



MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE

DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR

ON WHICH THE DISHWASHER WILL BE INSTALLED.

Remove the cover of the waste disposal unit (ref. A ﬁ g. 5-11).

Connect the dishwasher drain hose (ref. B ﬁ g. 5-11) to the air gap (ref. C

ﬁ g. 5-11) using the wide spring clamp (ref. D ﬁ g. 5-11); if necessary, cut the

end of the dishwasher drain hose (ref. E ﬁ g. 5-12) (do not cut the corrugated

section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”)

screw clamp*.

3. To connect the air gap (ref. C ﬁ g. 5-11) to the waste disposal unit inlet (ref. F

ﬁ g. 5-11), use a rubber union* (ref. G ﬁ g. 5-11) with spring or screw clamps*

(ref. H ﬁ g. 5-11).

* Available from any plumbing stockist

Fig. 5-11

INSTALLATION INSTRUCTION

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Pas de commentaire

Smeg STFABUWH Manuel d'installation Page 19