Smeg SCP112-8 Manuel de service télécharger pdf (Page 60)

Instructions for the user

126

9.5 What to do if...

The oven display is

completely off

• Check the mains power supply.

• Check whether an omnipolar switch upstream

of the oven supply line is in the “ON” position.

The oven does not heat up • Check whether it has been set in “showroom”

mode, for further details see “6.14 Secondary

menu”.

The controls do not

respond.

• Check whether it has been set in “child lock”

mode, for further details see “6.14 Secondary

menu”.

The cooking times are

longer than those indicated

in the table.

• Check whether it has been set in “PO” mode,

for further details see “6.14 Secondary menu”.

After the automatic

“pyrolysis” cleaning cycle

(only on some models) it is

not possible to select a

function.

• Verify whether the door locking device has

switched off. If it has not, the oven has a

protection device that does not allow functions

to be selected while the door locking device is

active. This is because the temperature inside

the oven is still too high to permit any type of

cooking.

The display shows ERR 4

(on pyrolytic models only)

• The door locking device has not properly

attached to the door. This might be because the

door was accidentally opened during its

activation. Switch off the oven and switch it on

again waiting a few minutes before selecting a

new cleaning cycle.

If the door is opened during

a fan-assisted function, the

fan stops.

• This is not a fault. It is a normal operation of the

appliance, useful when cooking foods in order

to avoid excessive heat escaping. When the

door is closed, the oven will return to normal

operation.

If the problem has not been resolved or in the case of other types of fault,

contact your local technical support centre.

1 2 ... 55 56 57 58 59 60 61 62 63 64

Commentaires sur ces manuels

Pas de commentaire

Smeg SCP112-8 Manuel de service Page 60

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Smeg SCP112-8