Smeg SCP490N-8 Manuel de service télécharger pdf (Page 20)

Instructions for the user

Modifying the set data

Once automatic cooking has started, its duration can be changed.

When and are steady and cooking is in progress, or the oven is in

standby waiting for cooking to start, press PT1 once. starts flashing and

PT1 can be turned to change the set duration.

Press PT1 again; goes out, starts to flash, and the cooking start time

will be displayed on DSP1. The cooking start time can be increased or

decreased by turning PT1.

A few seconds after the last change, and will appear (in steady mode)

on DSP1 and automatic cooking will restart with the new settings.

Once the desired function has been selected, the oven will begin cooking at the

preset temperature. Cooking is preceded by a pre-heating phase (common to

all functions) which allows the oven to reach the cooking temperature more

quickly.

This phase is indicated by flashing on the display (DSP1). At the end of the

pre-heating phase, will remain constantly on to indicate that the food can

be placed inside the oven.

7.7.4 Changing the preset temperature

The preset temperature for each function can be changed to suit the user's

requirements.

At any time while cooking is in progress, turn PT1 in either direction to increase

or decrease the cooking temperature by 5 degrees at a time. PT1 can also be

held in the left or right position to increase or decrease the setting more quickly.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Pas de commentaire

Smeg SCP490N-8 Manuel de service Page 20