Smeg DUSC36X Manuel de service télécharger pdf (Page 40)

Instructions for the installer

12.INSTALLING THE APPLIANCE

12.1 Electrical connection

The identification plate bearing the technical data, serial number and brand

name is visibly positioned on the appliance.

Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system

safety regulations.

If the appliance is connected to the power supply network by means of a fixed

connection, install a multipolar cut-out device on the power supply line, in

accordance with the installation rules, located near the appliance and in an

easily reachable position.

If a plug and socket connection is being used, make sure that the plug and

socket are compatible. Avoid use of adapters and shunts as these could cause

overheating and risk of burns.

Use H05VV-F type rubber cable and during positioning ensure that there is no

contact with the metallic parts of the external frame of the appliance To access

the terminal block, remove the rear cover of the appliance as described in

paragraph "12.2 Cable replacement". If necessary, change the position of the

jumpers on the terminal block as shown in the figure, then connect the cables,

ensuring that the earth cable is at least 20 mm longer than the others. Secure

the power cable to the appliance using the included cable ties.

WARNING: The values indicated above refer to the cross-section of the internal

conductor.

220 - 240V ~ Three pole 3 x 4 mm² H05VV-F

380 - 415V 2N~ Four pole 4 x 1.5 mm² H05VV-F

20 mm

1 2 ... 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Smeg DUSC36X Manuel de service Page 40