Smeg UKC7280NEP1 Manuel d'utilisateur télécharger pdf (Page 12)

Problem Possible cause Solution

Temperature cannot be set. The "FastFreeze function"

is switched on.

Switch off "FastFreeze func‐

tion" manually, or wait until the

function resets automatically

to set the temperature. Refer

to "FastFreeze function".

The temperature in the ap‐

pliance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

The food products' tem‐

perature is too high.

Let the food products temper‐

ature decrease to room tem‐

perature before storage.

Many food products are

stored at the same time.

Store less food products at the

same time.

The door has been

opened often.

Open the door only if necessa‐

ry.

The "FastFreeze function"

is switched on.

Refer to "FastFreeze function".

There is no cold air circu‐

lation in the appliance.

Make sure that there is cold

air circulation in the appliance.

If the advice does not lead to

the desired result, contact the

nearest Authorised Service

Centre.

Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

assembly instructions.

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

INSTALLATION

Location

Refer to the assembly

instructions for the installation.

To ensure best performance, install the

appliance well away from sources of heat

such as radiators, boilers, direct sunlight

etc. Make sure that air can circulate freely

around the back of the cabinet.

Positioning

Install the appliance in a dry, well

ventilated indoors where the ambient

temperature corresponds to the climate

12

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire