Smeg P23LINP Guide de dépannage télécharger pdf (Page 11)

Fire sparks but pilot does not light No gas to fire, check isolators are open.

Pipe work blockage, clean out.

Air not fully purged, re purge supply or wait longer.

Spark earthing to metal work, reset gap correctly.

locked pilot, clean out internally.

Pilot lights but then goes out Severe restriction in gas supply: clear obstruction.

Faulty thermocouple, replace pilot unit.

Blocked pilot, clean out.

locked lint gauze, clean.

Hold control knob in for longer.

Check control knob does not foul indicator plate.

If the pilot will not stay lit there is a problem with dirt,

the gas supply, or the thermocouple needs replacement.

Modifications are dangerous and can have a serious

unseen effect on safety. NEVER MODIFY OR BEND THE

THERMOCOUPLE TO MAKE THE PILOT STAY ALIGHT.

Fire does not spark at pilot HT lead detached, refit.

Check the spark gap (see section 7.1).

Faulty piezo unit, replace.

Debris shorting out electrode, clean.

Spark shorting to metalwork under tray, realign HT lead.

Fire runs for a time and then cuts off Loose or faulty thermocouple, rectify.

Blocked pilot, clean out.

Dirt or lint in pilot aeration hole or on the lint gauze,

clean thoroughly.

If the pilot will not stay lit there is a problem with dirt,

the gas supply, or the thermocouple needs replacement.

Modifications are dangerous and can have a serious

unseen effect on safety. NEVER MODIFY OR BEND THE

THERMOCOUPLE TO MAKE THE PILOT STAY ALIGHT.

Pilot flame shrinks when fire is on high Poor gas flow to fire, check pressure with fire on high.

If pressure is low, remove any restriction in pipework or

valve.

Check all isolators are adequately sized and fully open.

Check meter pressure is adequate.

If the pilot will not stay lit there is a problem with dirt,

the gas supply, or the thermocouple needs replacement.

Modifications are dangerous and can have a serious

unseen effect on safety. NEVER MODIFY OR BEND THE

THERMOCOUPLE TO MAKE THE PILOT STAY ALIGHT.

Fire smells when first lit or in use Newness smell from brand new appliance.

Leakage occurring. Carry out leakage test and rectify

any problems.

Combustible materials used in incorrect positions.

11.0 TROUBLESHOOTING GUIDE

GB IE

GB-IE-11

Smeg EU-wide instal instruc-v7-English.qxp:Smeg EU-wide installation instructions DRAFT A-12-12-07.qxd 17/7/08 12:07 Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire

Smeg P23LINP Guide de dépannage Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Smeg P23LINP